Savin SDC103A Service Manual download pdf (Page 498)

7.4 ORIGINAL SET AND ORIGINAL WIDTH SENSOR

1. Turn off the main switch.

2. Remove the upper cover [A] (7 screws).

3. Remove the pick-up solenoid spring [B].

4. Remove the stopper/pressure lever shaft [C] (2 E-rings).

5. Remove both front [D] and rear [E] feed-in cover magnet catches (1

screw each).

6. Remove the feed-in guide plate [F] (4 screws).

7. Remove the original set sensor assembly [G] (1 screw).

8. Remove the original width sensor assembly [H] (1 screw).

9. Replace the required sensor.

REPLACEMENT AND ADJUSTMENT

SM 7-21 A166/A187/A189

CÓPIA NÃO CONTROLADA

Savin SDC103A Service Manual Page 498