Savin SDC103A Service Manual download pdf (Page 342)

100

101

5. Apply setting powder to the entire drum surface [D].

NOTE: Be sure to apply the setting powder over the entire drum. This

prevents the cleaning blade from catching on the drum surface.

6. Rotate the drum forward two or three times to settle the setting powder

between the drum surface and cleaning blade.

NOTE: Do not the touch the drum beyond 10 mm from either side.

7. Install the drum unit using the reverse procedure of its removal.

8. After replacing the drum only, perform the process control

self-check for the new drum using following procedure.

1). Turn the main switch on. Then wait 10 minutes to remove the

residual voltage on the drum left by the initial process control

self-check.

2). Perform SP2-311 (Belt cleaning mode).

This is to apply a small amount of lubricant on the drum.

3). Perform SP3-126 (Forced process control).

This SP takes about 5 minutes.

4). Check the value of SP3-975 (Confirmation of the result).

Good result=01

Bad result = 80 to 99

If the value is a bad result, see section 2. (1.3.14).

NOTE: When replacing the drum and developer (or the development unit,

containing new black, cyan, magenta, and yellow developers), do the

SP modes listed in the SP Modes After Replacing and Cleaning table

in section 5, Maintenance.

[D]

A166R530.wmf

Replacement

and

Adjustment

DRUM UNIT

SM 5-9 A166/A187/A189

CÓPIA NÃO CONTROLADA

1 2 ... 337 338 339 340 341 342 343 344 345 346 347 ... 622 623

Comments to this Manuals

No comments

Savin SDC103A Service Manual Page 342

Comments to this Manuals

Related products and manuals for Multifunctionals Savin SDC103A