9. Remove the used toner tank [A] (1 connector and 1 plastic strip), while
turning up the opening [B] of the duct to prevent the scattering of toner.
Then turn down the transport release lever [C].
10. Lift the "handle" retainer [D], then remove the handle [E] from the back
side of the inner cover.
11. Attach the handle [E] to the development unit [F] (follow the steps
numbered
➀
through
➂
above).
CAUTION:
When the handle is pulled (step
➂
), ensure it attaches to the
development unit with a "click". If the handle is not correctly installed,
the development unit may fall when you attempt to remove it.
[A]
[B]
[C]
[D]
[E]
[E]
[F]
COPIER INSTALLATION
A166/A187/A189 3-12 SM
Comments to this Manuals