8.2 INSTALLATION PROCEDURE
CAUTION
Unplug the copier power cord before starting the following procedure.
NOTE: The film projector table (A579) must be installed before starting the
following procedure. (Refer to the Film Projector Table Installation
Procedure preceeding this section.)
1. Install the two positioning pins [A] on the table as shown (2 screws - M3 x
5); these are included in the A579 accessories.
2. Remove the following parts.
•
Rubber caps [B]
•
Rear cover [C] (4 screws)
•
Shield plate [D] (2 screws)
•
Front covers [E] (2 screws)
[A]
[C]
[B]
[D]
[E]
FILM PROJECTOR UNIT (A718) INSTALLATION
A166/A187/A189 3-54 SM
Comments to this Manuals