22. Slide the developer supply funnel [A] from the developer collection bottle [B].
23. Turn the development unit [C] to the developer installation position as shown.
24. Remove the developer cover [D] (1 screw [E]).
25. Attach the developer supply funnel [A] to the development unit using the
screw [E] (M4 x 6).
NOTE: 1) Before tightening the screw [E], ensure that the two tabs [F] are
completely inserted into the slots and the screw holes are aligned
correctly.
2) Be sure to use the correct screw [E] (M4 x 6) to attach the
developer supply funnel. If a screw longer than screw [E] is
used, the development paddle will be damaged by the longer
screw.
3) Hold the developer supply funnel in position when tightening
the screw. This is to prevent the screw holes from misaligning.
4) Never overtighten the screw [E]. If the screw is overtightened,
the development unit’s screw hole (made of aluminum) may be
damaged and the entire development unit may need to be
replaced.
[A]
[B]
[A]
[E]
[D]
Developer installation position
[C]
OK
[F]
Installation
Procedure
COPIER INSTALLATION
SM 3-17 A166/A187/A189
Comments to this Manuals