Savin SDC103A Service Manual download pdf (Page 388)

7.2.3 Entrance Seal Replacement

1. Remove the rear gear from the cleaning unit [A] (1 snap-ring).

2. Remove the rear plastic side plate [B] (2 screws).

3. Remove the cleaning entrance seal unit [C] and spring [E].

4. Remove the cleaning entrance seal bearings [D] at the both ends of the

unit (2 bearings).

NOTE: When installing a new cleaning entrance seal, make sure that it has

not been deformed.

Should the seal levers [E] fall-out during disassembly be sure to

reinstall in the proper position. Refer to parts catalog section 20

Transfer Belt Cleaning for proper position.

TRANSFER BELT UNIT

SM 5-55 A166/A187/A189

CÓPIA NÃO CONTROLADA

Savin SDC103A Service Manual Page 388