Savin SDC103A Service Manual download pdf (Page 241)

100

101

56. Rotate the revolver, while moving the toner supply motor unit [A] slightly to

the right, until the development unit bend plate [B] aligns with the toner catch

plate edge [C]. It does not matter which color is in position.

NOTE: The above step ensures the development unit is not misaligned

during installation. This is important for the following reasons:

1) If misaligned, the development roller drive gear (located on

the copier back side plate) could block the full insertion of the

unit by coming in contact with the development roller gear.

2) If this occurs, the revolver drive gear and the development roller

gear may accidentally mesh. The development roller gear may

then be driven in reverse. This could lead to developer spilling

inside the machine.

CAUTION:

Be careful not to hurt your back when holding the development unit.

Also, be careful not to drop the development unit. The development

unit weighs about 12 kg (26 lb).

57. Hold the development unit as shown above. Align the guide [D] with the

guide rail [E]. Then insert the development unit halfway.

NOTE: Never hold the hopper part [F] of the development unit when

installing the unit. Otherwise the hopper part will be broken or the

doctor gap of the development rollers will become incorrect.

[D]

[E]

[F]

[A]

[B]

[C]

COPIER INSTALLATION

A166/A187/A189 3-26 SM

CÓPIA NÃO CONTROLADA

1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 622 623

Comments to this Manuals

No comments

Savin SDC103A Service Manual Page 241

Comments to this Manuals

Related products and manuals for Multifunctionals Savin SDC103A