Savin SDC103A Service Manual download pdf (Page 239)

100

101

49. Place the drum unit on a clean sheet of paper or floor mat, as shown above.

Turn it over in the direction shown. Then remove the two screws [A] and

open the drum unit, as shown.

NOTE: 1) Use a clean sheet of paper or floor mat when placing the

drum unit on the floor. This stops the floor getting dirty.

2) Turn over the drum unit in the direction shown above. If turned in

the opposite direction, used toner from the drum may spill out.

50. Remove the drum protective sheet [B] and the cardboard cleaning blade release

wedge [C]. Apply setting powder to the drum’s surface if necessary, then

reassemble the drum unit by reversing the previous step. Do not apply an

excessive amount of setting powder to the drum when "dusting" the drum’s

surface.

51. Reinstall the drum unit (3 connectors).

NOTE: 1) When reinstalling the drum unit, ensure there is no gap at [D]

(the ends should be flush). If there is a gap, turn the drum

counterclockwise from the edge of the drum and reinsert the

drum in the machine. This ensures that the gears mesh correctly.

2) Ensure that all 3 connectors are securely connected before

proceeding with the installation.

3) Do not hold the drum at the hole at the rear. If the grounding

plate in this hole is bent, the drum will not contact the drum

shaft correctly.

[A]

[B]

[C]

Rev. 1/97

[D]

COPIER INSTALLATION

A166/A187/A189 3-24 SM

CÓPIA NÃO CONTROLADA

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 622 623

Comments to this Manuals

No comments

Savin SDC103A Service Manual Page 239

Comments to this Manuals

Related products and manuals for Multifunctionals Savin SDC103A