Savin SDC103A Service Manual download pdf (Page 165)

100

101

1. 1C Mode (Bk, C, M, Y)

Black

1. After the start key has been pressed, the drum motor starts, and the

drum and transfer belt turn continuously. The revolver does not move

because the black development section is already in place.

2. Shortly after the laser writes the image to the drum, the belt bias turns

on, and stays on until the end of the copy run (this is true for all modes).

C, M, or Y

1. After the start key has been pressed, the drum motor starts, and the

drum and transfer belt turn.

2. The revolver then rotates the required color development section into

position, and the laser writes the image to the drum.

3. The development unit goes back to the revolver H.P. position after the

toner has been transferred to the paper.

Multi-copy Mode

In multiple copy mode, the image of the second copy on the drum is

transferred to the transfer belt almost immediately after the previous toner

image, without detecting the belt mark. (There is no need to synchronize

latent images in 1C Bk, C, M, Y modes.)

2. 2C Mode for Red and Blue

2C and 4C modes use more than one color toner. Because of this, the

following points have to be kept in mind.

•

The toner images on the transfer belt have to be synchronized (the

leading edge of the toner image on the drum for the second color must

arrive at the leading edge of the toner image that is already on the belt for

the first color). To synchronize the latent images, the laser starts to write

to the drum when the transfer belt home position has been detected.

(Continued on the next page)

TRANSFER BELT UNIT

A166/A187/A189 2-96 SM

CÓPIA NÃO CONTROLADA

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 622 623

Comments to this Manuals

No comments

Savin SDC103A Service Manual Page 165

Comments to this Manuals

Related products and manuals for Multifunctionals Savin SDC103A