6. ROLLER DRIVE BELT REPLACEMENT
1. Remove the front cover [A] (1 screw).
2. Remove the rear cover [B] (1 screw) and the sorter hinge [C] (2 screws).
3. Remove the rear flat cover [D] (2 screws).
4. Lift off the top cover [E].
5. Lift the upper paper guide [F] up and out of position (1 grounding wire).
6. Remove the entrance guide bracket [G] (2 screws).
7. Lift the lower paper guide [H] out of position and turn it over to remove
the roller drive belt [I].
NOTE:
Be careful not to damage the bin home position switch actuator
[J] when reassembling.
8. Remove the transfer spacer [K], wheel [L], pin [M], and bushing [N] on
both sides of the shaft.
9. Slide the wheel shaft towards the front and replace the roller drive belt.
[K]
[L]
[I]
[M]
[N]
[F]
[H]
[D]
[E]
[A]
[J]
[G]
[C]
[B]
Sorter
A557
FSM 13-9 A156/A160/A162
Comments to this Manuals