Savin 4027 Service Manual download pdf (Page 351)

6.4.2 Wire Installation

1. Put the bead [A] at the end of the wire in the slot in the wire pulleys [B,

2. Insert the pin [D] into the bin drive shaft [E] and then push in the wire

3. Wind the wire one and a half turns as shown and put the bead [F] in the

slot in the bin support block [G].

4. Put the bin support block stopper [H] on the bin support block.

5. Run the wires over the pulleys [Front wire: I/J/K, Rear wire: L/M/N/O] and

put the bead [P] in the slot in the bin lift shaft [Q].

6. Reassemble the sorter stapler.

When installing the bin drive bracket, make sure that the bin lift

wires are wound from the inner side to the outer side of the

pulleys as shown.

599mm (23.58")

877.6 mm (34.55")

A156/A160/A162 10-24 FSM

CÓPIA NÃO CONTROLADA

Savin 4027 Service Manual Page 351