Savin 4027 Service Manual download pdf (Page 164)

100

101

4.2 DRUM REPLACEMENT

1. Pull out the drum unit from the copier. (See Drum Unit Removal.)

2. Remove the drum charge roller ass’y (see Drum Charge Roller Replacement).

3. Loosen the two screws [A] and remove the bearing holder [B].

4. While holding the front and rear ends of the drum, remove the drum [C] from

the drum unit by lifting it up.

5. Remove the bearing [D] (1 screw [E]) from the old drum and install it on the

new drum. Also, remove the protective sheet from the new drum.

6. Set the new drum [F] in the unit and install the bearing holder again

(2 screws).

NOTE:

1) When setting the drum in the unit, be careful not to strike it against

the rail.

2) Do not bend the bearing holder. Make sure the bearing holder is in

contact with the bearing, as they are both used to ground the unit.

If they are not in contact, solid black copies may occur.

[C]

[D]

[E]

[A]

[B]

[F]

Replacement &

Adjustment

FSM 5-17 A156/A160/A162

CÓPIA NÃO CONTROLADA

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 707 708

Comments to this Manuals

No comments

Savin 4027 Service Manual Page 164

Comments to this Manuals

Related products and manuals for Multifunctionals Savin 4027