Savin 7800W User Manual download pdf (Page 55)

Settings You Can Change with User Tools

• Auto Off Time(+15): You can set the time the machine waits after the last op-

eration before switching itself off automatically. The time can be set by

minute from 1 to 240 minutes.

Note

❒ Default: 30min

❒ Auto Off cannot be used in the following cases.

• When the Wait indicator goes on

• When the toner end indicator goes on

• When the front door is open

• While copying

• When a paper misfeed occurs or SC call appears

• The machine cannot enter the Auto Off mode if the roll end indicator

lights while copying repeatedly.

• Original Hold Mode(+16): After original scanning is finished, the original

exit roller stops before completely feeding out the original. This is to prevent

the original from dropping onto the floor after scanning. The original is fed

out when the X key is pressed or when the next original is inserted.

Note

❒ 0: No, 1: Original Hold Mode

❒ Default: 1

• Length Size Magnification(+17): Adjust the speed of the original feed motor.

The setting can be changed from —1.0 to 1.0 by 0.05% steps.

Note

❒ Default: 0.0

• Synchro-cut Length Adjustment(+19): Adjust the cut length in the synchro

cut, preset cut, and variable cut modes . The setting can be changed from —

25 to 25 by 1mm steps.

Note

❒ Default: 0

• Paper Length Up/Down Setting(+20): Select if the paper length is count

down or up when the preset cut key is pressed.

Note

❒ 0: Down count, 1: Up count

❒ Default: 0

• Paper Length Up/Down Speed Setting(+21) :The copier can scroll through

the preset lengths forward or backward, and at different speeds. There are

many sets of sizes from which to choose.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 94 95

No comments

Savin 7800W User Manual Page 55