Savin 7800W User Manual download pdf (Page 44)

Copy Settings

Partial Copying

The Partial Copy function copies only a part of an original.

You need to enter start and end points in the feed direction of the original .

Note

❒ You cannot use the Partial Copying function when using the Rear Table.

❒ You cannot use the Partial Copying function for originals shorter than

255mm.

❒ If you set the start point within 155 mm of the leading edge of the original, the

copier will regard the leading edge as the start point.

❒ The minimum available space between the start point and the end point is 30

mm.

❒ If you do not set the end point after setting the start point (a), the copier will

regard the trailing edge of the original as the end point (b).

❒ If you set the start point within 40mm of the trailing edge of the original, the

copier will cancel the copying and eject the original.

❒ If you set the end point within 40mm of the trailing edge of the original, the

copier will regard the trailing edge as the end point.

❒ In the Synchro Cutting function, the copier will cut the paper in a length from

the start point to the end point.

❒ When the Partial Copying function is selected, the copier will reset the set-

tings for the trailing edge margin, the leading edge margin in the Synchro

Cutting function, and the Repeated Copying function.

Hold down the {

{{

{Function Select}

}}

} key for 3 seconds or more.

original Bypass Table

Preset/Variable Cut Mode

Synchro Cut Mode

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 94 95

No comments

Savin 7800W User Manual Page 44