Savin AC205 User Manual download pdf (Page 298)

Page 2-6 Administrator Guide

Print Driver Installation for Networked Printers

Windows 2000 (TCP/IP)

NOTE: Windows 2000 supports printing via TCP/IP as standard when TCP/IP is

installed on a Windows 2000 Workstation.

Use the Add Printer Wizard to add the printer to the network.

¾ Select [Start], select [Settings], and then select [Printers].

Double-click on the [Add Printer] icon to display the Add Printer Wizard.

¾ Select [Local printer], uncheck the box labelled [Automatically detect and install my

Plug and Play printer.]and then select [Next] to display the dialog box listing available

ports.

¾ Select [Create a new port] to display the Printer Ports dialog box.

Select [Standard TCP/IP Port] and select [Next] to display the Add Standard TCP/IP Port

dialog box.

Enter the IP Address of the printer in the [Printer Name or IP Address] field (you can

optionally enter a friendly name for the printer port you are creating or use the default

name created). Then select [Next] to continue.

If the network printer settings are not automatically detected, click on the [Custom] button

to setup the network printer port settings.

It is recommended that you select [Raw] as the Print Protocol.

If you prefer to use LPR:

Select [LPR] as the Print Protocol.

Enter [lp] (in lower case) in the [Queue Name] field.

Uncheck the box labelled [LPR Byte Counting Enabled]

Check the box labelled [SNMP Status Enabled].

The [Community Name] should normally be set to “public” (unless you have configured

the device to have a custom SNMP community name) and the [SNMP Device Index]

should be set to 1.

Select [OK].

¾ The Add Printer Wizard will then request that you select the driver to be used for this

printer.

Insert the CD ROM with the printer drivers into the workstation and select [Have Disk].

1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 338 339

No comments

Savin AC205 User Manual Page 298