Savin 9022 Operations Instructions download pdf (Page 8)

cRIO-9022 Operating Instructions and Specifications 8 ni.com

Powering On the Controller

Turn on each power supply to the CompactRIO system. The controller runs

a power-on self test (POST). During the POST, the Power and Status LEDs

turn on. When the Status LED turns off, the POST is complete. If the LEDs

do not behave in this way when the controller powers on, refer to the

Understanding LED Indications section.

Configuring IP Settings and Installing Software

on the Controller

When you power on the controller for the first time, it boots into safe mode

because there is no software installed on it. This section describes how to

configure the IP settings and install software on the controller.

Complete the following steps.

1. Launch MAX on the host computer and expand Remote Systems in

the MAX configuration tree. MAX lists the cRIO controller as the

model name of the controller followed by the MAC address, for

example, NI-cRIO-902200802f108562.

Tip If you cannot find the controller under Remote Systems, refer to the CONSOLE OUT

Switch section for information about using a serial connection and a terminal program for

troubleshooting.

The controller automatically attempts to connect to the network using

DHCP. If DHCP is not available, the controller connects to the network

with a link-local IP address with the form

169.254.x.x.

2. Select the controller under Remote Systems to see the Network

Settings tab in the middle pane of MAX.

3. Enter a name for the RT target in the Name field.

4. Select settings for the RT target in the IP Settings section, then click

Apply.

Note For information about configuring network settings, refer to the Configuring

Network Settings book of the MAX Remote Systems Help. In MAX, click Help»Help

Topics»Remote Systems. On the Contents tab, browse to LabVIEW Real-Time Target

Configuration»Configuring Network Settings.

5. When you click Apply, you are prompted to reboot the controller for

the changes to take effect. Click Yes. You can also reboot the controller

by right-clicking the name under Remote Systems and selecting

Reboot.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 22 23

No comments

Savin 9022 Operations Instructions Page 8